Description Rheem Electric Storage Sacrificial Anode Anode Rods are the most important line of defence in increasing water heater tank life and preventing leaks. These devices work because the metal in the rod is more easily corroded than the metal of the water heater tank. You should check and replace your Anode Rod on a regular basis. When the rod is depleted, it can no longer protect your tank What does the Sacrificial Anode do? Sacrificial Anodes are mostly steel core rods covered with either magnesium, aluminium and zinc. Mostly they are installed on the top of hot water tanks. They are designed to corrode via electrolysis instead of the tank itself corroding as it is a softer metal. Generally depending on the quality of the water and the amount of water, a sacrificial anode will require replacement in 4-5 years. Always service the anode at 5 year intervals in a metro household hot water system as recommended by manufacturers Read more Different types A Blue anode (normally Aluminium) must be used in hard water conditions to prolong the hot water systems life. Take care not to use a hard water anode in a soft water situation as this will cause other issues due to the anode over-reacting. Remember: Once the anode has diminished, electrolysis will attack the tank causing corrosion and dramatically shortening the life of the hot water system How do I replace the Rheem Electric Storage Sacrificial Anode ? Isolate the water heater and relieve the pressure by lifting the TPR valve (1). Remove the anode cap (2). Using a tube or socket spanner remove the anode (3). Apply thread seal tape to replacement anode, refit and tighten. Note: It may be necessary to cut the anode to length prior to fitting Restore water supply and check for leaks. Refit the anode cap. Purge air from the system through hot taps and restore the power supply to the water heater.
